Project Evo 9 MR-SE finally made it to the track
Dec 29, 2023, 08:06 PM
#16
Are you running X or Standard control arms? Those also dont look OEM though the MR could look different.
For bumpsteer, are you running an offset rear control arm bushing? If so, you want to remove the WL tie-rod and go back to OEM. The 5mm difference works well to compensate for offset CA bushing and Top hat combo.
For bumpsteer, are you running an offset rear control arm bushing? If so, you want to remove the WL tie-rod and go back to OEM. The 5mm difference works well to compensate for offset CA bushing and Top hat combo.
The following users liked this post:
black E (Dec 29, 2023)
Dec 29, 2023, 11:22 PM
#17
Are you running X or Standard control arms? Those also dont look OEM though the MR could look different.
For bumpsteer, are you running an offset rear control arm bushing? If so, you want to remove the WL tie-rod and go back to OEM. The 5mm difference works well to compensate for offset CA bushing and Top hat combo.
For bumpsteer, are you running an offset rear control arm bushing? If so, you want to remove the WL tie-rod and go back to OEM. The 5mm difference works well to compensate for offset CA bushing and Top hat combo.
Im thinking the car is too low and the dampers are crap?
Thread
Thread Starter
Forum
Replies
Last Post
DontStopMe
Evo Show / Shine
15
Jan 13, 2021 07:57 PM
DontStopMe
Motor Sports
21
Jun 13, 2013 07:07 AM
DontStopMe
Evo Show / Shine
71
Jul 25, 2012 11:09 AM